4-20 Control Functions
B- Standard position
A- Minimum (soft)
E- Maximum (hard)
1. Special wrench
DC socket
The DC socket is located at the front right side
of the ATV aside the ignition switch.
The DC socket can be used for work lights,
radios, etc.
The DC socket can provide 8.5A/12V DC
current for approximately 1 hour.
The DC socket should only be used when the
engine is running.
[1]. DC socket
How to use the DC socket
1. Set the light switch to “OFF” turning off all
the lights.
2. Start the engine, (See pages 6-1—6-2.)
To Next Page
Loading...
