6-2 Operation
5. Press the “Start” button, then the engine
starts.
NOTE:
When the gear shift is in the Neutral (N)
position, see if the “N” indicator on the
display is on. If not, check circuits on the
ATV.
CAUTION:
Read the “Engine break-in” section prior
to operating the engine for the first time.
Starting a warm engine
To start a warm engine, refer to the
“Starting a cold engine” section. The
throttle should be opened slightly.
Warming the engine
To achieve the maximum service life of
engine, always warm up the engine before
starting .
Never accelerate hard with a cold engine!
To make sure the engine is warm, start with
one third throttle for the first 3km drive; or
let the engine warm for 3 minutes at 2000
rpm.
Engine shut down
Press the emergency shut off button in,
then the engine will shut down.
Or turn the ignition key to “OFF”, which will
turn off the engine as well.
NOTE
When you turn off the ignition switch there
is a three minute run time for the fan to
continue to cool and prevent the coolant
To Next Page
Loading...
