Cleaning and Storage 9-2
With buffing wax on the surface of
chrome-plate. but buffing wax will damage
the surface of plastic.
When finished, start engine, make it is in an
idle state in a few minutes at the same time.
WARNING
Moisture brake will reduce the function of
brake, and increase the possibility of
accident.
So testing the function of the brake after
cleaning. Run the brake under the lower
speed many times in order to wipe dry the
friction plate.
Storage
Always take preventive actions to avoid its
function turns bad when you want to storage
your ATV (60 days or more longer).Store
your ATV following the procedures outlined
below after cleaning:
Keep the oil tank and oil pipe is clean and
without any oil.
Knock down the spark plug, pull the oil SAE
10W30 or 20W40 into the spark plug hole,
and re-install the spark plug, and then roll the
engine in order to distribute the oil on the
cylinder wall.
Lubricate all the control cables.
Elevate the frame so that all the wheels off
the ground.
To Next Page
Loading...
