4-8 Control Functions
Toggle switch “” to turn on the high
beams.
Toggle switch “OFF” to turn off all the lights.
Toggle switch “ ” to turn on the parking
lights and the taillights.
NOTE:
Do not use the headlights with the engine off
for more than fifteen minutes. Otherwise the
battery may run out and the vehicle cannot
start. If this happens, remove the battery and
recharge it.
Ignition switch “ ”
The starter motor cranks the engine when this
button is pushed.
NOTE:
See starting instructions prior to starting the
engine. (See P6-1—6-2)
Turn signal switch
Moving the turn signal switch left or right, the
turn signal light will be on with a buzzer
sound.
Engine emergency stop switch
“ / ”
Make sure that the engine emergency stop
switch is set to “” before starting the
engine. The engine stop switch controls
ignition and can be used at all times to stop
the engine, especially in an emergency. The
engine will not start or run when the
emergency stop switch is set to “”.
To Next Page
Loading...
