CROSSJET AC 92-18 - Driving and Slope Operation; Driving; Driving Speed; Driving on Slope

To repair or change parts that are not described in this manual contact the nearest authorized service
centre or the sale shop where you bought your machine.Have the authorized service centre perform the
following maintenance:
• electromagnetic clutch adjustment
• break setting
• engine tune up and adjustment
• V-belt change
• hydraulic system bleeding process (model AC92-23 4x4)
• front axle adjustment and setting (model AC92-23 4x4)
• any other problems with the hydraulic system (model AC92-23 4x4)
• in case of additional problems
Use only original spare parts during repairs.
7.2 TIRE PRESSURE INSPECTION
Inspect the tire pressure regularly. Make sure the pressure is according to the requirements. Other than the
recommended pressure values may worsen the driving capabilities of your machine or may even cause loss of
control.
• Front wheel tire pressure 150 kPa
• Rear wheel tire pressure 80kPa
7.3 BATTERY MAINTENANCE
Perform the battery maintenance according to instructions described in the battery user's manual.
7.4 ENGINE MAINTENANCE
Perform the engine maintenance according to instructions described in the engine user's manual.
7.4.1 OIL CHANGE
The engine is equipped with oil drain screw.
• Place a flat container that may safely take at least 2 liters of oil under the engine.
Slide a piece of suitable wood under the opposite side of the drain screw to lift
the machine slightly.
That way you better drain the oil out of the engine.
• Unscrew the drain screw and loosen the oil-filling lid to
ensure easy oil drain.
•
When all oil is drained, screw the screw back and fill the engine with suitable
oil. Make sure to pour in the correct amount of oil. (See the engine user's manual).
Close the oil filling lid.
• Take the used oil to the recycling facility for further processing.
7.4.2 AIR FILTER CHANGE
Make sure to follow instructions in the user's manual when
changing the air filter.
7.4.3 SPARK PLUG MAINTENANCE
Perform the spark plug maintenance according to the instructions described in the engine user's manual.
7.4.4 FUEL FILTER CHANGE
Perform the fuel filter change according to the instructions described in the engine user's manual.
7.4.5 ENGINE COOLING SYSTEM MAINTENANCE
Before each use and during work inspect the engine grill. The grill must be free of grass or other foreign subjects.
If needed clean the grill!
After every 100 hours of use or once a year, remove the ventilator cover and clean all clogged areas and the
cooling engine ribs. That way you prevent engine overheating. If needed, clean the cooling system more often.
Caution !!!
Regularly remove grass, dust and other flammable dirt from the area around the exhaust.
Do not perform any repairs if you do not have the required tools or do not have enough experience with
combustible engine repairs.
45