Chapter 6. Status
6-5
Type the Wan Parameters;
VPI: 0
VCI: 32
AAL5 Encap: LLC
Protocol: IPoA , EoA , IPoA + NAT
or EoA + NAT
Note: The Protocol used in CO and
CPE have to be the same.
Click Next to setup the IP
parameters.
For more understanding about NAT, review NAT/DMZ in page 19.
IP Address: 192.168.20.1
Subnet mask: 255.255.255.0
Gateway: 192.169.30.2
Click Next
The screen will prompt with the parameters that will be written in Flash. Check the parameters
before writing to Flash.
Press Restart to restart the router working with new parameters or press continue to setup another
parameter.
To Next Page
Loading...
