STEERING
11
10. Remove the steering plate.
11. Remove the hex cap screw, shoulder spacer and
hex nut in the middle of the steering gear using
two 9/16” wrenches. See Figure 3.13.
NOTE: Note the order the spacers and washer
were removed so that they can be installed prop-
erly. See Figure 3.14.
Figure 3.13
Steering gear
Steering plate
Figure 3.14
12. Remove the bolt that the steering gear pivots on
using two 9/16” wrenches. See Figure 3.13.
NOTE: When installing the steering gear, coat
the steering gear and the steering plate with a
high quality lithium grease.
13. Install the steering and steering pivot gears by
following the previous steps in reverse order.
14. Perform a wheel alignment by following the
steps described in the steering alignment sec-
tion of this chapter.
15. Test run the tractor in a safe area before return-
ing it to service.
To Next Page
Loading...
