BODY PANELS
24
6e. Carefully lift the fender assembly off of the
tractor.
NOTE: On tractors equipped with a Kohler sin-
gle cylinder engine, the front of the fender
mounts to the outrigger using a rubber bushing
and steel spacer. See Figure 4.33.
NOTE: The handle assemblies can be removed
from the rear fenders using a 3/8” wrench, from
beneath the fender. See Figure 4.34.
NOTE: With the handle assembly removed, the
steel reinforcement plate can be unbolted from
the top side of the fender using a 3/8” wrench.
See Figure 4.35.
Figure 4.33
Rubber
bushing
Steel spacer
Figure 4.34
Screws that hold
the handle assembly
Steel reinforcement plate
Figure 4.35
Reinforcement plate
mounting screws
To Next Page
Loading...
