CVT Drive and brake system
81
10. Remove the torque bracket bolts using a 1/2”
wrench. See Figure 6.80.
11. Take the nuts off of the T-bolts that hold the tran-
saxle to the frame using a 1/2” wrench.
See Figure 6.81.
NOTE: At this point, the brake actuator spring is
still attached to the brake rod from the pedal
shaft, and the brake arm on the transaxle.
Figure 6.80
Torque bracket bolts
Figure 6.81
T-bolts
12. Carefully lower the transaxle out of the tractor.
See Figure 6.82.
13. Move the transaxle forward to make some slack
in the brake linkage. Use the slack to unhook the
brake spring from the brake rod.
See Figure 6.83.
Figure 6.82
Figure 6.83
Brake rod
Unhook here
To Next Page
Loading...
