Cupra ATECA - Page 198

Infotainment System
Updating and using navigation data
from an SD card
3 Only available for the model: Navi System
The SD car
d is factory fitted in slot 2 for SD
cards.
Navigation data that is currently valid for this
unit in order to allow all functions to be used
in full.
Updating navigation data
The current navigation data can be downloa-
ded in the internet at www.seat.com and
stored in a SD card compatible with the unit.
Suitable SD Cards can be acquired at SEAT
dealerships.
The procedure is described on the internet
at www.seat.com.
Using navigation data
●
Insert the memory card
››
›
page 187.
●
Wait for the testing icon to disappear.
If the inserted memory card contains naviga-
tion data, the following message appears:
“The source contains a valid naviga-
tion database”. Navigation can be started.
Note
●
The inserted memory card must be pre-
pared before it is ejected
›››
page 187.
●
Navig
ation is not possible without the SD
card.
●
Do not remove the memory card while
the navigation data is in use. This could
damage the memory card!
●
The navigation memory card cannot be
used as a memory for other files.
●
CUPRA recommends using only the origi-
nal SEAT cards. The use of other memory
cards could limit its operation.
Updating and installing navigation da-
ta
3 Only av
ailable for the model: Navi System Plus
The Infotainment system is equipped with an
internal navigation data memory. The re-
quired navigation data are already installed
on the system.
The Infotainment system always requires the
navigation data that is currently valid for this
unit in order to allow all functions to be used
in full. Using an old version may lead to errors
during navigation.
Updating navigation data
To update navigation data visit our website:
www.seat.com.
The navigation data must be installed after
downloading. Na
vigation is not possible from
the memory card.
Installing navigation data
The installation process takes about 2 hours.
If the Infotainment system is switched off,
the installation process is paused and will au-
tomatically resume when switched back on.
●
Switch the ignition on.
●
Insert the memory card containing the
navigation data
›››
page 187.
●
Press the infotainment key  > Settings
> System information.
●
Press UPDATE to import the stored naviga-
tion data.
●
Follow the instructions displayed on the
screen.
Once installed, the memory card can be re-
moved. The memory card must be prepared
for removal
›››
page 187.
CAUTION
Do not remove the memory card while the
navigation data is being installed. The
memory card may be irreparably damaged!
Note
●
The navigation memory card may not be
used as memory storage for other files. The
196