Cupra ATECA - Cruise Control System (CCS); Driver Assistance Systems

Driving
Driving on flooded roads
To prevent damage to the vehicle driving on
flooded roads, t
ake the following into ac-
count:
●
The water should never come above the
lower edge of the bodywork.
●
Drive at pedestrian speed.
WARNING
After driving through flooded zones, brak-
ing effectiveness can decrease if the brake
discs or pads are damp
›››
page 275.
CAUTION
●
Driving through flooded areas may dam-
age vehicle components such as the en-
gine, transmission or electrical system.
●
Whenever driving through water, the
Start-Stop system* must be switched off
›››
page 230.
Note
●
Check the depth of the water before en-
tering the flooded zone.
●
Do not stop in the water, drive in reverse,
or stop the engine.
●
Vehicles travelling in the opposite direc-
tion cause waves that could exceed your
vehicle's critical height.
●
Avoid driving thr
ough salt water (corro-
sion)
›››
page 343.
Trips abroad
●
With petrol vehicles, it should be ensured
that lead-fr
ee petrol is available throughout
the journey
›››
page 314, Fuel types. Seek
information about service station networks
selling unleaded fuel.
●
In some countries, it is possible that your
vehicle is not sold and some spar
e parts may
not be available or the technical services
may only be able to make limited repairs.
CUPRA distributors and importers will pro-
vide information about the technical prepa-
ration that your vehicle requires and also
about necessary maintenance and repair
possibilities.
CAUTION
CUPRA does not accept liability for any
damage to the vehicle due to the use of a
lower quality fuel, an inadequate service or
the non-availability of genuine spare parts.
Driver assistance systems
Cruise control system (CCS)*
Control lamp

It lights up green
The Cruise Control System (GRA) is switched on and
active.
OR: The Adaptive Cruise Control system (CCS) is
switched on and active.
OR: the speed limiter is switched on and active.
The control lamps light up when the ignition
is s
wit
ched on and should turn off after ap-
proximately 2 seconds. This is the time taken
for the function check.
WARNING
Observe the safety warnings
›››
in Con-
trol and w
arning lamps on page 79.
246