Driving
Trailer mode
Fig. 242
Parking assist display on the screen with
trailer attached.
On vehicles with a factory-fitted trailer hitch,
when the tr
ailer is connect
ed, the rear sen-
sors will not activate when reverse gear is en-
gaged or button is pressed. Therefore,
any objects behind or to the side of the vehi-
cle will not be indicated on the screen and
no audio signals will sound.
The screen will only display objects detected
at the front, and the vehicle's trajectory will
be hidden.
Manoeuvre braking function*
3 Only valid with P
arking System Plus
The emergency braking function is used to
minimise damage in the event of a collision.
Depending on the equipment, if the Parking
Aid is active, the br
aking while manoeuvring
function activates emergency braking when
it detects an obstacle in the vehicle’s path
that could cause a collision, driving forwards
or in reverse.
The function will not brake if the Parking Aid
is activated automatically. For the system to
operate, manoeuvring speed must be be-
tween 2.5 and 10 km/h (between 1.5 and 6
mph) for the front area and between 1.5 and
10 km/h (between 1 and 6 mph) for the rear.
Following an intervention, the braking while
manoeuvring function will be inactive in the
same direction of travel for 5 metres. Once
the gear is changed, or the selector lever’s
position is changed, the function will be ac-
tive again. The Parking Aid’s limitations ap-
ply.
The braking while manoeuvring function is
controlled in the Easy Connect system with
the button > SETTINGS > Parking and
manoeuvring.
●
on – permits the use of the braking
while manoeuvring function.
●
off – does not permit the use of the
br
aking while manoeuvring function.
Temporary suppression of emergency
braking
●
When the function is de
activated with the
Manoeuvre braking button that appears on
the Parking assist screen of the Easy Con-
nect system.
●
Whenever any of the car doors, rear lid or
bonnet are opened.
Rear parking aid*
Description
The r
ear parking aid is an audible and visual
assist
ant that warns of obstacles located be-
hind the vehicle.
There are sensors integrated in the rear
bumper. When they detect an obstacle, you
are alerted by audible warnings and visually
on the Easy Connect system.
If the Top View Camera* is installed, the rear
parking aid will issue an audible warning
about objects near the rear of the vehicle,
and the Top View Camera* image will be
available on the Easy Connect screen, giving
a real image of the objects around the car.
Make particularly sure that the sensors are
not covered by adhesives, residues, dirt and
the like, as this could affect the system's op-
eration. Cleaning instructions
›››
page 344.
294
To Next Page
Loading...
