Help with parking and manoeuvring
The approximate measurement range of the
r
e
ar sensors is:
0.60 m
1.60 m
As you approach the obstacle, the frequency
of the audible signals will increase. The signal
will sound continuously at around 0.30 m:
Stop!
›››
in Introduction on page 290,
›
›
›
in Introduction on page 290!
If the separ
ation is maint
ained, the warning
volume is reduced after about 4 seconds.
Parking Aid operation
Parking Aid connection
●
Select reverse gear.
P
arking Aid disconnection
●
Place the select
or level in position P, N or
D (for automatic gearboxes) or disengage re-
verse (for manual gearboxes).
Set the lever to the N or D position to main-
tain the system active for approximately 8
seconds before switching off. During that
time, Parking assist will switch off if:
●
The selector lever is moved to position P.
●
OR: the vehicle accelerates to approx.
15 km/h (9 mph) or faster.
Side area:
Central area:
If the Top View Camera* is installed, rear
parking aid will be automatically deactivated
when disengaging reverse gear.
Manual disconnection of Parking Aid dis-
play (the audible sounds remain active)
●
Press a button on the main menu of the
factory-assembled infotainment system.
●
OR press the BACK function button.
Temporary suppression of sound in Park-
ing Aid
●
Press the function button. If you have
the Top View Camera* system installed, you
cannot use the temporary suppression of
sound in Parking Aid.
Change from reduced view to full view
●
Select reverse gear.
●
OR: on vehicles fitted with reverse assist
(Rear View Camera “RVC”) click on the car
icon of the reduced display.
Switch to the reverse assist image (Rear
View Camera “RVC”)
●
Select reverse gear.
●
OR: press the RVC function button.
Setting the indications and audio signals
The indications and audio signal settings are
in Easy Connect*
›››
page 80.
●
Rear volume*: volume in the rear area.
●
Rear sound settings/treble*: sound
tone in the rear area.
●
Lower volume: when the parking aid is
switched on, the volume of the audio source
will be reduced, depending on the selected
option.
Error messages
If a an error or fault message appears on the
instrument panel in Parking assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If there is a fault in a sensor, the symbol is
displayed on the Easy Connect display.
We recommend taking the vehicle to a spe-
cialised workshop to have the fault repaired.
Towing device
In vehicles equipped with a towing bracket
device from the factory, when the trailer is
connected, the parking aid will not be activa-
ted when reverse gear is engaged.
295
To Next Page
Loading...
