Curtis MultiMode 1207B - Page 4

iv
Curtis 1207B Manual
FIGURES
fig. 1: Curtis 1207B motor controller
and 1311 handheld programmer ................................ 1
fig. 2: Mounting dimensions, Curtis 1207B controller ........3
fig. 3: Standard wiring diagram (series motors) .................... 6
fig. 4: Compound motor wiring diagram .............................8
fig. 5: Wiring for 5kΩ–0 throttle ......................................10
fig. 6: Wiring for 20kΩ potentiometer
used as a wigwag-style throttle ................................10
fig. 7: Wiring for 0–5V throttle ........................................11
fig. 8: Wiring for 3-wire pot throttle ..................................12
fig. 9: Wiring for Curtis ET-XXX electronic throttle .........12
fig. 10: Wiring for 0–5kΩ throttle ......................................13
fig. 11: Alternative wiring for emergency reverse check .......13
fig. A-1: Ramp shape, with max speed = 100%
and creep speed = 0% ........................................... A-7
fig. A-2: Ramp shape, with max speed = 100%
and creep speed = 10% .......................................... A-7
fig. A-3: Ramp shape, with max speed = 60%
and creep speed = 10% .......................................... A-8
TABLES
table 1: LED codes .............................................................. 20
table 2: Troubleshooting chart ............................................
22
FIGURES / TABLES