Curtis MultiMode 1207B User Manual

Curtis 1207B Manual
3
2 9 J U N E 2 0 1 2 D R A F T
INSTALLATION AND WIRING
MOUNTING
The 1207B controller can be oriented in any position, but the location should
be carefully chosen to keep the controller as clean and dry as possible. If a
clean mounting location cannot be found, a cover must be used to shield
the controller from water and contaminants.
To ensure full rated output power, the controller should be fastened to
a clean, flat metal surface with three screws. The case outline and mounting
hole dimensions are shown in Figure 2.
Although not usually necessary, a thermal joint compound can be used
to improve heat conduction from the case to the mounting surface.
2 — INSTALLATION & WIRING
2
Fig. 2 Mounting
dimensions,
Curtis 1207B controller.
66 (2.6)
28 (1.1)
122
(4.80)
152 (6.00)
6.3 (0.25)
22 (0.85)
66
(2.60)
4.8 (0.19)
21 × 16 × 1.5
(0.83
× 0.63 × 0.06);
8.4 (0.33) dia. hole thru
6.7 (0.265) dia.,
3 plcs
Dimensions in millimeters and (inches)
Status LED
C
L
165 (6.50)
127 (5.00)

Curtis MultiMode 1207B Specifications

General

Brand	Curtis
Model	MultiMode 1207B
Category	Controller
Language	English