Custom Audio Electronics K3 - Page 58

K3 BT
DEVICE NAME AND
FIRMWARE MODULES
RELEASE
PRINTHEAD
STATUS
PRINTER SETTINGS
1 •••••••• 576
----------------------------------------------------------------------------
PRINTHEAD WORKING GOOD!
PRINTER TYPE ....................................<device model>
Wi-Fi Module .........................................<Wi-Fi module>
PRINTING HEAD TYPE........................<printhead model>
INTERFACE ..........................................RS232
ETHERNET TYPE.................................10/100Base-Tx
PROGRAM MEMORY TEST.................OK
DYNAMIC RAM TEST...........................OK
EXTERNAL MEMORY TEST ................OK
CUTTER TEST......................................OK
HEAD VOLTAGE [V] = 23.37
HEAD TEMPERATURE [°C] = 25
POWER ON COUNTER = 4
PAPER PRINTED [cm] = 40
CUT COUNTER = 1
ETH. SPEED = 10Mb/s Half-Duplex MDIX
[Network configuration]
DHCP Client .................................... : Disabled
IP Address ....................................... : 192.168.0.1
Subnet Mask ................................... : 255.255.240.0
Default Gateway.............................. : 192.168.0.5
[Ethernet]
MAC Address .................................. : 00-00-00-00-00-00
[Wi-Fi]
SSID ................................................ : Custom
Security Type................................... : WPA2
MAC Address .................................. : 00-00-00-00-00-00
Wireless........................................... : Bluetooth
Printer ID ......................................... : 000000000000000
Paring PIN ....................................... : 1234
AutoReconnect................................ : Disabled
Pairing ............................................. : Enabled
Wireless........................................... : Wi-Fi
Printer Emulation............................. : CUSTOM/POS
RS232 Baud Rate ........................... : 115200 bps
RS232 Data Length......................... : 8 bits/chr
RS232 Parity ................................... : None
RS232 Handshaking ....................... : Hardware
Busy Condition ................................ : RxFull
USB Class ....................................... : Printer
USB Address Number ..................... : 0
Print Mode ....................................... : Normal
Autofeed .......................................... : CR Disabled
Code Table [num] ............................ : 0
Font Type......................................... : International
Chars / inch ..................................... : A=15 B=20 cpi
Speed / Quality................................ : Normal
Print Width....................................... : 72mm[80PaperW]
Paper Threshold .............................. : 40%
Black mark Position......................... : Bottom
Black mark Threshold...................... : 40%
Black mark Distance [mm]............... : +15
Total cut ........................................... : Enabled
PaperEnd Buffer Clear .................... : Disabled
PrintHead Test PowerOn................. : Disabled
Data Logger..................................... : Disabled
Line Space Reduction ..................... : Disabled
Line Feed Reduction ....................... : Disabled
Barcode Height Reduct ................... : Disabled
Auto Cover Open............................. : Enabled
Power Management ........................ : Disabled
Print Density.................................... : 0%
[ FEED ] enter Printer setup
[ OPEN ] skip Setup
<device name>
SCODE <code> - rel 1.00
DCODE <code> - rel 1.00
FCODE <code> - rel 1.00
KEYS FUNCTIONS
DEVICE
STATUS
ETHERNET
PARAMETERS
WI-FI
PARAMETERS
BLUETOOTH
PARAMETERS
PARAMETERS
FOR DEVICE
CONFIGURATION
58