6.7 Operating parameters
The parameters marked with the symbol
D
are the default values.
PRINTER EMULATION Available emulations for the device:
CUSTOM/POS
D
PRINT MODE Printing mode:
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
CHARS / INCH Font selection:
A = 11 cpi, B = 15 cpi
A = 15 cpi, B = 20 cpi
D
A = 20 cpi, B = 15 cpi
CPI = Characters Per Inch
CODE TABLE [num]
See
paragraph 9.6
numbers set with this parameter.
The character tables set with this parameter are the same set with the command 0x1B
0x74 (refer to the commands manual of the device).
setting of two digits for the tens and the units:
CODE TABLE [num x 10]
Setting the digit for tens:
0
D
2 4
1 3 5
CODE TABLE [num x 1]
Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
FONT TYPE Setting of the font type:
International
D
Chinese GB 18030
When the chinese font is enabled, the selection of the character code table is suspended
(“Code table” parameter). When the Chinese fonts is disabled, it returns the character
code table previously in use (“Code table” parameter).
68
To Next Page
Loading...
