Custom Audio Electronics K3 - Configuration by Software

6.2 
The setup parameters can be set by using the “PrinterSet” software tool available on
www.custom4u.it.
For a detailed description of the device operating parameters see the following paragraphs.

Start “PrinterSet” software tool.
Click on LOAD > FROM DEVICE and select
the device connected to the PC.
From Device
From File
SAVE
PORT
LOAD
Select a configuration file as follows:
Click on LOAD > From file and select a .psc file on your PC
Drag and drop a .psc file
Connect the device to a PC directly (see paragraph 4.5),
without using HUB devices.
2
3
1
Connect the device to a PC directly (see paragraph 4.2),
without using HUB devices.
59