SPEED / QUALITY Setting of printing speed and printing quality:
Normal
D
High Quality
High Speed
Gray scale
PRINT WIDTH Width of printing area:
50mm [58 PaperW]
54mm [60 PaperW]
72mm[ 80 PaperW]
D
PAPER THRESHOLD Threshold value (in percent) for the recognition of the presence of paper by the paper
presence sensor:
30% 60% 90%
40%
D
70%
50% 80%
TOTAL CUT Sets the behavior of the cutter when the total cut command 0x1B 0x69 (ESC i) is sent:
Disabled = The total cut command 0x1B 0x69 (ESC i) will be ignored and the device
executes a partial cut
Enabled
D
= The total cut command 0x1B 0x69 (ESC i) will be executed.
PAPEREND BUFFER
CLEAR
Disabled
D
portion of the ticket after that the new paper is loaded.
PRINTHEAD TEST
POWERON
Setting of the performing of the print head test:
Disabled
D
= the test is performed only during the printing of the setup report
Enabled = the test is performed at each power on
DATA LOGGER Setting of the data logger function on the LOG folder on the Flash memory:
Disabled
D
= data logger function disabled
69
To Next Page
Loading...
