CYBELEC CybTouch Series User Manual

User Manual – CybTouch series
CybTouch series – User Manual
JAN.
2020
V5.0
58/98
MSG NR.
MESSAGE
DESCRIPTION
E65
The beam is not indexed
This message appears when trying to move the crowning manually
and the beam is not indexed.
E66
Fw Axes Error 33 [Maximum
voltage time exceeded (10V)]
This is a regulator error. The axis could not follow its trajectory. This
may be due to higher friction, resistance or an obstacle on the axis
movement. It may also be a drive problem.
Call a technician.
E67
Fw Axes Error 39 [Speed
tracking error]
This is a regulator error. The axis could not follow its trajectory. It
may be due to higher friction, resistance or an obstacle on the axis
movement. It may also be a drive problem.
Call a technician.
E68
Fw Axes Error 316 [MinPosition
or MaxPosition outside limit ! ]
Axis position counter is out of max or min limit.
Verify physical axis position and set the axis counter accordingly.
E69
The machine is not indexed ! No
limit
Before the machine is indexed, the NC doesn’t know where the axes
are. In manual page, movements are authorized but the electronic
stroke limits are not activated. Operator is responsible for stopping
axis movement before mechanical limit is reached.
E70
Progr. angle is smaller than the
die angle
The programmed angle is smaller than the die angle. Change die.
E71
Progr. angle is smaller than the
punch angle
The programmed angle is smaller than the punch angle. Change
punch.
E72
Depth safety
The calculated angle causes the punch, material, and die to collide
and approach coining mode. Operator must confirm to proceed.
E73
Collision back gauge-tool
This message appears to warn that, with the parameters cannot be
entered as such, for they would cause a collision between the back
gauge and the tools. Check your parameters’ values.
E74
Beam error No [ ][ ][ ]
This message indicates an error of the beam. The first number
refers to the message number (see Beam Error Messages).
E75
Beam: static gains not found
E76
Error in the parameter beam
(you must correct it before
continuing)
E77
Error in the sequence
parameter (you must correct it
before continuing)
E78
RS232: parity error
E79
RS232: overrun
E80
RS232: framing
E81
RS232: noise
E82
Security module event No xx
E83
Security module error time out
E84
Security module error
checksum
E85
Security module error buffer
rec to small
E86
File access error
There was an error when trying to access a file while
programming an option. Make sure that the code was entered
properly. If it is not working, try and restart the NC. If the problem
persists, contact Cybelec.

CYBELEC CybTouch Series Specifications

General

Brand	CYBELEC
Model	CybTouch Series
Category	Control Systems
Language	English