CYBELEC DNC 60 GS User Manual

PAGE 60 USER GUIDE DNC 60 GS
RS232
Indicates a transfer from a PC towards a DNC.
RUN
Indicates that the transmission is being made
correctly. This message flashes slowly for the
duration of the transmission.
StopCycl
Indicates that the
/STOPCYCLE
input has
been de-activated. The current sequence will
finish and the machine will wait for a new front
panel
START
.
STOPPED
Indicates that the machine has been stopped by
pressing the
stop key on the front panel.
STORED
Indicates that the storage operation has been
made correctly.
Synchro
The maximum authorized separation
(X1<->X2) has been exceeded.
TEACHED
The
TEACH
operation has been made correctly.
TEST
Indicates that the DNC is in communication
TEST
mode.
TIME OUT
Indicates that the DNC has not received any
valid information since the beginning of the
transmission, and thus returns the command to
the operator. This message appears after about
30 seconds.
UNDEFINED
Refusal to change to
or , if the
parameters vital to execution are only partially
programmed and thus prevent the verification
calculations.
Variat
Informs that the
Variator OK
input is no longer
present. The functioning of the variator must be
controlled.
ZonIndex
This message appears when an axis is already in
an index zone and that the N2X programming of
this axis prohibits an automatic exit from this
index zone. In this case you should refer to the
N2X user manual under parameter N° 25.

CYBELEC DNC 60 GS Specifications

General

Brand	CYBELEC
Model	DNC 60 GS
Category	Control Systems
Language	English