TRANSMISSION PAGE 45
T
RANSMISSION
For transfer to an IBM PC by serial line the DNC 60 must be equipped with
the option RS232.
Backup The PC must be equipped with the CYBACK storage software.
CYBACK allows to make a backup of the data in the DNC without
intervention on the data on the PC's level.
Updating Easy, practical and very rapid, this possibility facilitates in case of necessity
the updating of the DNC software in the FLASH memory.
The PC must be equipped with the updating software.
! Call the
TRANSFER DNC <
--
> PC
page via the main menu.
DNC <-> PC STATUS STOPPED
TRANSFER 1 1 DNC --> PC
2 PC --> DNC
3,4 DATA LINK TEST 1 2
7 FLASH
8 EXT KEYBD
9 MODEM
CHOICE _ 1 PRODUCTS
4 PARAMETERS
6 PRODUCTS N°
__ ( )
__ ( )
__ ( )
Who commands ?
This page will only be used to initialize the transmission type. It is not
possible to start the transmission from the DNC, this will always be done
from the PC.
TRANSFER
Allows to select the type of transmission.
DNC
#
##
#
PC
Initializes the transmission PC-DNC. Mode
1
or
2
can be selected indifferently.
DATA LINK TEST
Selects the test mode of the serial ports.
See the following chapter.
FLASH
Prepares the DNC to receive an updating.
EXT KEYBD
Puts the DNC in external terminal mode.
See the concerned chapter.
MODEM
Not yet available.
CHOICE
This field allows to select the objects to be
transferred.
In the case of option
6 PRODUCTS N°
, it is
necessary to fill in the last fields of the page with
the numbers of the products to be transferred.
To Next Page
Loading...
Need help?
General
