DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
To create a new tunnel, click the ADD button ( ) in the Tunnels section.
!
Setting for both devices which establish the tunnel should be the same.
Figure 139. The page for adding an IPsec tunnel. The General Settings section.
You can specify the following parameters:
Parameter Description
General Settings
Dynamic IPsec
Move the switch to the right to allow a remote host with any public IP
address to connect to the access point via IPsec protocol. Such a
setting can be specified for one IPsec tunnel only. Connection requests
via this tunnel can be sent by a remote host only.
Page 182 of 235
To Next Page
Loading...
