DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Parameter Description
Type
Select an identification method for the remote host (router) from the
drop-down list:
• Address: The remote host is identified by its IP address.
• FQDN: The remote host is identified by its domain name.
The drop-down list is displayed if the Dynamic IPsec switch is
moved to the left.
Remote host
Enter the remote subnet VPN gateway IP address if the Address
value is selected from the Type drop-down list.
Enter the remote subnet VPN gateway domain name if the FQDN
value is selected from the Type drop-down list.
The field is available for editing if the Dynamic IPsec switch is
moved to the left.
Identifier value
Specify a unique name of the tunnel.
Pre-shared key
A PSK key for mutual authentication of the parties. Click the Show
icon ( ) to display the entered key.
Local WAN
A WAN connection through which the tunnel will pass. Select a value
from the drop-down list.
• Interface: When this value is selected, the Interface drop-
down list is displayed. Select an existing WAN connection
from the list.
• All interfaces: When this value is selected, the access point
uses the default WAN connection.
NAT Traversal
The NAT Traversal function allows VPN traffic to pass through the
NAT-enabled device. DAP-600P allows to forcibly encapsulate VPN
traffic in UDP packets for passing through a remote device regardless
of whether it supports address translation.
If you need to enable forced encapsulation of VPN traffic, select the
Enabled value.
If you need to disable forced encapsulation of VPN traffic, select the
Disabled value.
Page 183 of 235
To Next Page
Loading...
