10/100 Fast Ethernet Switch User’s Guide
36 Using the Console Interface
♦ 9,600 baud
♦ 8 data bits
♦ No parity
♦ One stop bit
You can also access the same functions over a TELNET interface.
Once you have set an IP address for your Switch, you can use a
TELNET program (in a VT-100 compatible terminal mode) to
access and control the Switch. All of the screens are for the most
part identical, whether accessed from the console port or from a
TELNET interface.
Console Usage Conventions
The console interface makes use of the following conventions:
1. Items after a colon”:” are read-only values, displayed for
information purposes. The cursor cannot be moved to these
items.
2. Items in <angle brackets> can be toggled on or off using the
space bar.
3. Items in [square brackets] can be changed by typing in a
new value. You can use the backspace and delete keys to
erase characters behind and in front of the cursor.
4. The up and down arrow keys, the left and right arrow keys,
the tab key and the backspace key, can be used to move
between selected items. It is recommended that you use the
tab key and backspace key for moving around console.
To Next Page
Loading...
