10/100 Fast Ethernet Switch User’s Guide
4 Introduction
♦ Full and Half-duplex (for both 10Mbps and 100Mbps) to
allow two communicating stations to transmit and receive at
the same time.
♦ Auto polarity detection for correction of incorrect polarity on
the receive twisted pair at each port.
♦ Data forwarding rate 14,880 pps per port at 100% of wire-
speed for 10Mbps speed.
♦ Data forwarding rate 148,800 pps per port at 100% of wire-
speed for 100Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at
14,880 pps per port at 100% of wire-speed for 10Mbps speed.
♦ Data filtering rate eliminates all error packets, runts, etc. at
148,800 pps per port at 100% of wire-speed for 100Mbps
speed.
♦ 8K active MAC address entry table per device with self
learning and table aging.
♦ 8 MB packet buffer per device.
♦ Supports broadcast storm rate filtering.
Management
♦ RS-232 console port for out-of-band network management
via a PC.
♦ Spanning Tree Algorithm Protocol for creation of alternative
backup paths and prevention of indefinite network loops.
♦ D-View Network Management Program for standard SNMP-
based management.
To Next Page
Loading...
