10/100 Fast Ethernet Switch User’s Guide
Using the Console Interface 65
5. Enter the desired Port Priority in the Port Priority (0-255)
field.
6. Go to the SAVE command and save the STAP Port
Parameters.
7. Choose EXIT to leave the STAP Port Parameters.
The PREPORT command allows you to see the parameters of the
previous port, and the NEXTPORT command allows you to see the
parameters of the next port
.
Figure 6-22. STAP Port Parameters
Resetting the Switch
You can use the console interface to reset the Switch stack, either
doing a System Reset (which restarts the Switch and is identical
to powering the Switch off and back on again) or a Factory Reset
(which sets all of the Switch’s parameters to what they were when
the Switch was delivered from the factory).
To Next Page
Loading...
