10/100 Fast Ethernet Switch User’s Guide
Using the Console Interface 67
Figure 6-24. Factory Reset
2. Move the cursor to Yes to confirm the reset and press Enter.
3. The main menu screen should appear. Move the cursor to
the TCP/IP Parameters Configuration Menu and input: the
IP Address, Subnet Mask and Default Gateway. The Send
BootP Request Upon Power Up is an optional field for your
response. Using the spacebar, toggle your response in this
field at this time.
4. Move the cursor to SAVE and press Enter.
5. Move the cursor to EXIT and press Enter. The Switch
should restart, and all of its parameters will be reset to their
default values.
To Next Page
Loading...
