DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
101
Figure 6- 51. Access Rule Configuration (Packet Content Mask)
To set the Access Rule for the Packet Content Mask, adjust the following parameters and
click Apply.
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select
Permit
to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are
not forwarded by the Switch and will be filtered.
Access ID Type in a unique identifier number for this access. This value can be set from
1 – 50.
Type
Selected profile based on Ethernet (MAC Address), IP address, or Packet
Content Mask. Ethernet instructs the Switch to examine the layer 2 part of
each packet header. IP instructs the Switch to examine the IP address in
each frame’s header. Packet Content Mask instructs the Switch to examine
the packet header.
To Next Page
Loading...
