DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
100
802.1p(0-7) Enter a value from 0-7 to specify that the access profile will apply only
to packets with this 802.1p priority value.
Ethernet Type Specifies that the access profile will apply only to packets with this
hexadecimal 802.1Q Ethernet type value (hex 0x0-0xffff) in the
packet header. The Ethernet type value may be set in the form: hex
0x0-0xffff, which means the user may choose any combination of
letters and numbers ranging from a-f and from 0-9999.
To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the
following screen:
Figure 6- 49. Access Rule Display window (Ethernet)
To configure the Access Rule for Packet Content Mask, open the Access Profile Table
(figure 6-35) and click Modify for an Ethernet entry. This will open the following screen:
Figure 6- 50. Access Rule Table (Packet Content Mask)
To remove a previously created rule, select it and click the button. To add a new Access
Rule, click the Add button:
To Next Page
Loading...
