DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
99
Figure 6- 48. Access Rule Configuration window (Ethernet).
To set the
Access Rule
for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access
profile are forwarded by the Switch, according to any additional rule
added (see below).
Select Deny to specify that packets that do not match the access
profile are not forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be
set from 1 – 50.
Type
Selected profile based on Ethernet (MAC Address), IP address, or
Packet Content Mask. Ethernet instructs the Switch to examine the
layer 2 part of each packet header. IP instructs the Switch to examine
the IP address in each frame’s header. Packet Content Mask
instructs the Switch to examine the packet header.
Priority(0-7)
Select this option to instruct the Switch to use the 802.1p priority
value entered in the adjacent field for packets that meet the criteria. A
number between 0, the lowest priority, and 7, the highest priority, can
be entered.
Vlan Name
Allows the entry of a name for a previously configured VLAN.
Source Mac Source MAC Address - Enter a MAC Address for the source MAC
address.
Destination Mac Destination MAC Address - Enter a MAC Address mask for the
destination MAC address.
To Next Page
Loading...
