DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
98
Dscp(0-63) This field allows the user to enter a Dscp value in the space provided, which
will instruct the Switch to examine the DiffServ Code part of each packet
header and use this as the, or part of the criterion for forwarding. The user
may choose a value between 0 and 63.
Protocol
This field allows the user to modify the protocol used to configure the
Access Rule Table
; depending on which protocol the user has chosen in
the Access Profile Table. In the example above, IGMP is the protocol chosen
and therefore the user may modify the IGMP settings for this access profile.
To view the settings of a previously correctly configured rule, click in the
Access Rule
Table to view the following screen:
Figure 6- 46. Access Rule Display window (IP)
To configure the Access Rule for Ethernet, open the Access Profile Table (figure 6-40) and
click Modify for an Ethernet entry. This will open the following screen:
Figure 6- 47. Access Rule Table
To remove a previously created rule, select it and click the button. To add a new Access
Rule, click the Add button:
To Next Page
Loading...
