DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
97
Figure 6- 45. Access Rule Configuration window (IP)
Configure the following
Access Rule Configuration
settings:
Parameter Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are
not forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from
1 – 50.
Type
Selected profile based on Ethernet (MAC Address), IP address, or Packet
Content Mask. Ethernet instructs the Switch to examine the layer 2 part of
each packet header. IP instructs the Switch to examine the IP address in
each frame’s header. Packet Content Mask instructs the Switch to examine
the packet header.
Priority (0-7)
Select this option to instruct the Switch to use the 802.1p priority value
entered in the adjacent field for packets that meet the criteria. A number
between 0, the lowest priority, and 7, the highest priority, can be entered.
Replace Dscp (0-63)
Select this option to instruct the Switch to replace the DSCP value (in a
packet that meets the selected criteria) with the value entered in the adjacent
field.
Vlan Name Allows the entry of a name for a previously configured VLAN.
Source IP
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP
Destination IP Address- Enter an IP Address mask for the destination IP
address.
To Next Page
Loading...
