DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
96
the offset value specified:
value(0-15) - Enter a value in hex form to mask the packet from the
beginning of the packet to the 16
th
byte.
value(16-31) - Enter a value in hex form to mask the packet from byte 16 to
byte 31.
value(32-47) - Enter a value in hex form to mask the packet from byte 32 to
byte 47.
value(48-63) - Enter a value in hex form to mask the packet from byte 48 to
byte 63.
value(64-79) - Enter a value in hex form to mask the packet from byte 16 to
byte 31.
Port The user may set the Access Profile Table on a per-port basis by entering
an entry in this field. Entering all will denote all ports on the Switch.
Click Apply to implement changes made.
To establish the rule for a previously created Access Profile:
In the Configuration folder, click the Access Profile Table link opening the Access Profile
Table. Under the heading Access Rule, clicking Modify, will open the following window.
Figure 6- 44. Access Rule Table window
To create a new rule set for the access profile click the Add button. A new window is
displayed. To remove a previously created rule, select it and click the
button.
To Next Page
Loading...
