DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
92
Figure 6- 41. Access Profile Table (Ethernet)
The following parameters can be set for Ethernet:
Parameter Description
Profile ID (1-255)
Type in a unique identifier number for this profile set. This value can be set
from 1 – 255.
Type
Select profile based on Ethernet (MAC Address), IP address, or packet
content mask. This will change the menu according to the requirements for
the type of profile. Select Ethernet to instruct the Switch to examine the
layer 2 part of each packet header. Select IP to instruct the Switch to
examine the IP address in each frame’s header. Select
Packet Content
Mask to specify a mask to hide the content of the packet header.
Vlan
Selecting this option instructs the Switch to examine the VLAN part of each
packet header and use this as the full or partial criterion for forwarding.
Source Mac
Source MAC Mask - Enter a MAC address mask for the source MAC
address.
Destination Mac
Destination MAC Mask - Enter a MAC address mask for the destination MAC
address.
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority value
of each packet header and use this as the, or part of the criterion for
forwarding.
Ethernet type
Selecting this option instructs the Switch to examine the Ethernet type value
in each frame’s header.
Port
The user may set the Access Profile Table on a per-port basis by entering
a port number in this field.
The page shown below is the IP Access Profile Configuration page.
To Next Page
Loading...
