DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
99
accounting commands LEVEL {default | METHOD-LIST}
no accounting commands LEVEL
Parameters
Specifies to do accounting for all configure commands at the
specified privilege level. Valid privilege level entries are 1 to 15.
Default
By default, this option is disabled.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
For accounting via the method list to take effect, enable AAA first by using the aaa new-model
command. Create the method list first by using the aaa accounting commands command. If the
method list does not exist, the command does not take effect. The user can specify different method
lists to account commands at different levels. A level can only have one method list specified.
Example
This example shows how to enable the command accounting level 15 configure command issued via
the console using the accounting method list named “cmd-15” on the console.
Switch# configure terminal
Switch(config)# aaa accounting commands 15 cmd-15 start-stop group tacacs+
Switch(config)# line console
Switch(config-line)# accounting commands 15 cmd-15
Switch(config-line)#
8-15 accounting exec
This command is used to configure the method list used for EXEC accounting for a specific line. Use
the no form of this command to disable the accounting EXEC option.
accounting exec {default | METHOD-LIST}
no accounting exec
Parameters
To Next Page
Loading...
