D-Link DGS-1510 Series User Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
519
58. Router Advertisement (RA) Guard
Commands
58-1 ipv6 nd raguard policy
This command is used to create an RA guard policy. The command will enter into the RA guard policy
configuration mode. Use the no form of this command to remove an RA guard policy.
ipv6 nd raguard policy POLICY-NAME
no ipv6 nd raguard policy POLICY-NAME
Parameters
POLICY-NAME
Specifies the IPv6 RA guard policy name.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create an RA guard policy. This command will enter into the RA guard policy
configuration mode.
Example
This example shows how to create an RA guard policy named policy1.
Switch# configure terminal
Switch(config)# ipv6 nd raguard policy policy1
Switch(config-ra-guard)#
58-2 device-role
This command is used to configure the role of the attached device. Use the no form of this command
to revert to the default setting.
device-role {host | router}
no device-role
Parameters
host
Specifies to set the role of the attached device to host.
router
Specifies to set the role of the attached device to router.
Default
By default, this option is host.
Command Mode

D-Link DGS-1510 Series Specifications

General

Layer	Layer 2+
IGMP Snooping	Yes
Static Routing	Yes
Humidity	10% to 90% non-condensing
Series	DGS-1510
Type	Smart Managed Switch
VLAN Support	Yes
QoS	Yes
Management	Web-based, CLI, SNMP
Power Supply	Internal
MAC Address Table	16K entries
802.3ad Link Aggregation	Yes
Spanning Tree Protocol (STP)	Yes, STP/RSTP/MSTP
Jumbo Frame Support	Yes, up to 9KB
Power Consumption	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p