DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
523
59. Safeguard Engine Commands
59-1 clear cpu-protect counters
This command is used to clear the CPU protect related counters.
clear cpu-protect counters {all | sub-interface [manage | protocol | route] | type
[PROTOCOL-NAME]}
Parameters
Specifies to clear all CPU protect counters.
sub-interface [manage |
protocol | route]
Specifies to clear the CPU protect related counters of sub-
interfaces. If no sub-interface is specified then the CPU protect
related counters of all sub-interfaces will be cleared.
Specifies to clear the CPU protect related counters of the specified
protocol. If no protocol name is specified, then all protocols will be
cleared.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
If this command is issued without parameters, then all CPU protect related counters will be cleared.
Example
This example shows how to clear all CPU protect related statistics.
Switch# clear cpu-protect counters all
Switch#
59-2 cpu-protect safeguard
This command is used to enable or configure the Safeguard Engine. Use the no form of this
command to disable the Safeguard Engine.
cpu-protect safeguard [threshold RISING-THRESHOLD FALLING-THRESHOLD]
no cpu-protect safeguard [threshold]
Parameters
(Optional) Specifies to configure the utilization to control when the
Safeguard Engine function will activate.
Specifies to set a percentage value of the rising CPU utilization
which will trigger the Safeguard Engine function. Once the CPU
utilization rises over the specified percentage, the Safeguard
Engine mechanism will initiate. The valid range is from 20 to 100.
To Next Page
Loading...
Need help?
General
