D-Link DGS-1510 Series - Appendix D - IETF RADIUS Attributes Support

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
706
Appendix D - IETF RADIUS Attributes Support
Remote Authentication Dial-In User Service (RADIUS) attributes carry specific authentication,
authorization, information and configuration details for the request and reply. This appendix lists the
RADIUS attributes currently supported by the switch.
RADIUS attributes are supported by the IETF standard and Vendor-Specific Attribute (VSA). VSA
allows the vendor to create an additionally owned RADIUS attribute. For more information about D-
Link VSA, refer to the RADIUS Attributes Assignment Appendix.
IETF standard RADIUS attributes are defined in the RFC 2865 Remote Authentication Dial-In User
Service (RADIUS), RFC 2866 RADIUS Accounting, RFC 2868 RADIUS Attributes for Tunnel Protocol
Support, and RFC 2869 RADIUS Extensions.
The following table lists the IETF RADIUS attributes supported by the D-Link switch.
RADIUS Authentication Attributes:
Number
IETF Attribute
1
User-Name
2
User-Password
3
CHAP-Password
4
NAS-IP-Address
5
NAS-Port
6
Service-Type
7
Framed-Protocol
8
Framed-IP-Address
12
Framed-MTU
18
Reply-Message
24
State
26
Vendor-Specific
27
Session-Timeout
29
Termination-Action
30
Called-Station-ID
31
Calling-Station-ID
32
NAS-Identifier
60
CHAP-Challenge
61
NAS-Port-Type
64
Tunnel-Type
65
Tunnel-Medium-Type
77
Connect-Info
79
EAP-Message
80
Message-Authenticator
81
Tunnel-Private-Group-ID
85
Acct-Interim-Interval