D-Link DGS-1510 Series - Sflow Commands

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
544
62. sFlow Commands
62-1 sflow receiver
This command is used to configure a receiver for the sFlow agent. Receivers cannot be added to or
removed from the sFlow agent. Use the no form of this command to reset one receiver to the default
settings.
sflow receiver INDEX [owner NAME] [expiry {SECONDS | infinite}] [max-datagram-size SIZE]
[host {IP-ADDRESS | IPV6-ADDRESS}] [udp-port PORT]
no sflow receiver INDEX
Parameters
INDEX
Specifies the index of the receivers.
owner NAME
(Optional) Specifies the owner name of the receiver with a
maximum of 32 characters. The user cannot directly configure the
owner as an empty string.
expiry SECONDS
(Optional) Specifies the expiration time for the entry. The parameter
of the entry will reset when the timer expired. The range is from 0 to
2000000. The user cannot directly configure the expiry timer as 0.
infinite
(Optional) Specifies that the entry will not be expired.
max-datagram-size SIZE
(Optional) Specifies the maximum number of data bytes of a single
sFlow datagram. The valid range is from 700 to 1400.
host IP-ADDRESS
(Optional) Specifies the IPv4 address of the remote sFlow collector.
host IPV6-ADDRESS
(Optional) Specifies the IPv6 address of the remote sFlow collector.
udp-port PORT
(Optional) Specifies the UDP port of the remote sFlow collector. The
default is 6343. The range is from 1 to 65535.
Default
The default owner name is an empty string.
The expiry timer is 0 seconds.
The maximum datagram size is 1400 bytes.
The receiver IP address is 0.0.0.0.
The UDP port number is 6343.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The sFlow agent has a fix number of receivers distinguished by index. They are created in reset the
state by the system and cannot be removed. Configure the owner of an entry before configuring other
parameters of the entry. The owner of an entry can only be configured when the entry is in the reset
state. The user cannot configure the owner name as an empty string. Once the owner is configured, it
cannot be changed directly. It can only be reset by the no sflow receiver command.
Use the no sflow receiver command to reset the receiver. When a receiver expired, the receiver is
disabled and the receiver entry will be reset to the default settings. The expiration timer starts to count
down when its value is configured. The user cannot configure the expiry timer as 0.
Example