EasyManuals Logo

D-Link DGS-1510 Series User Manual

D-Link DGS-1510 Series
711 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
111
9. Basic IPv4 Commands
9-1 arp
This command is used to add a static entry in the Address Resolution Protocol (ARP) cache. Use the
no form of this command to remove a static entry in the ARP cache.
arp IP-ADDRESS HARDWARE-ADDRESS
no arp IP-ADDRESS HARDWARE-ADDRESS
Parameters
IP-ADDRESS
Specifies the network layer IP address.
HARDWARE-ADDRESS
Specifies the local data-link Media Access (MAC) address (a 48-bit
address).
Default
No static entries are installed in the ARP cache.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The ARP table keeps the network layer IP address to local data-link MAC address association. The
association is kept so that the addresses will not have to be repeatedly resolved. Use this command
to add static ARP entries.
Example
This example shows how to add a static ARP entry for a typical Ethernet host.
Switch# configure terminal
Switch(config)# arp 10.31.7.19 0800.0900.1834
Switch(config)#
9-2 arp timeout
This command is used to set the ARP aging time for the ARP table. Use the no form of this command
to revert to the default setting.
arp timeout MINUTES
no arp timeout
Parameters
MINUTES
Specifies the dynamic entry that will be aged-out if it has no traffic
activity within the timeout period. The valid values are from 0 to
65535.
Default
The default value is 20 minutes.

Table of Contents

Other manuals for D-Link DGS-1510 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DGS-1510 Series and is the answer not in the manual?

D-Link DGS-1510 Series Specifications

General IconGeneral
LayerLayer 2+
IGMP SnoopingYes
Static RoutingYes
Humidity10% to 90% non-condensing
SeriesDGS-1510
TypeSmart Managed Switch
VLAN SupportYes
QoSYes
ManagementWeb-based, CLI, SNMP
Power SupplyInternal
MAC Address Table16K entries
802.3ad Link AggregationYes
Spanning Tree Protocol (STP)Yes, STP/RSTP/MSTP
Jumbo Frame SupportYes, up to 9KB
Power ConsumptionVaries by model
DimensionsVaries by model
WeightVaries by model
Operating Temperature0°C to 40°C
Storage Temperature-40°C to 70°C
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p

Related product manuals