EasyManuals Logo

D-Link DGS-1510 Series User Manual

D-Link DGS-1510 Series
711 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #275 background imageLoading...
Page #275 background image
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
272
The command is available for both physical ports and port-channel interface configuration. As a
forbidden port of a VLAN, a port is forbidden from becoming a member port of the VLAN via the
GVRP operation. The VLAN specified by the command does not need to exist.
This command only affects the GVRP operation. The setting only takes effect when GVRP is enabled.
The command only takes effect for hybrid mode and trunk mode.
Example
This example shows how to configure the interface eth1/0/1 as a forbidden port of VLAN 1000 via the
GVRP operation.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# gvrp forbidden 1000
Switch(config-if)#
31-7 gvrp timer
This command is used to configure the GVRP timer value on a port. Use the no form of this command
to revert the timer to the default setting.
gvrp timer [join TIMER-VALUE] [leave TIMER-VALUE] [leave-all TIMER-VALUE]
no gvrp timer [join] [leave] [leave-all]
Parameters
join
(Optional) Specifies to set the timer for joining a group. The unit is in
a hundredth of a second.
leave
(Optional) Specifies to set the timer for leaving a group. The unit is
in a hundredth of a second.
leave-all
(Optional) Specifies to set the timer for leaving all groups. The unit
is in a hundredth of a second.
TIMER-VALUE
(Optional) Specifies the timer value in a hundredth of a second. The
valid range is 10 to 10000.
Default
Join: 20.
Leave: 60.
Leave-all: 1000.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the GVRP timer value on a port.
Example
This example shows how to configure the leave-all timer to 500 hundredths of a second on interface
eth1/0/1.

Table of Contents

Other manuals for D-Link DGS-1510 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DGS-1510 Series and is the answer not in the manual?

D-Link DGS-1510 Series Specifications

General IconGeneral
LayerLayer 2+
IGMP SnoopingYes
Static RoutingYes
Humidity10% to 90% non-condensing
SeriesDGS-1510
TypeSmart Managed Switch
VLAN SupportYes
QoSYes
ManagementWeb-based, CLI, SNMP
Power SupplyInternal
MAC Address Table16K entries
802.3ad Link AggregationYes
Spanning Tree Protocol (STP)Yes, STP/RSTP/MSTP
Jumbo Frame SupportYes, up to 9KB
Power ConsumptionVaries by model
DimensionsVaries by model
WeightVaries by model
Operating Temperature0°C to 40°C
Storage Temperature-40°C to 70°C
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p

Related product manuals