D-Link DGS-1510 Series - IP-MAC-Port Binding (IMPB) Commands

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
319
37. IP-MAC-Port Binding (IMPB) Commands
37-1 clear ip ip-mac-port-binding violation
This command is used to clear IP-MAC-Port Binding (IMPB) blocked entries.
clear ip ip-mac-port-binding violation {all | interface INTERFACE-ID | MAC-ADDRESS}
Parameters
all
Specifies to clear all of the violation entries.
interface INTERFACE-ID
Specifies to clear the violation entries created by the specified
interface.
MAC-ADDRESS
Specifies to clear the violation entries of the specified MAC address.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the command to delete the IMPB violation entry from the filtering database.
Example
This example shows how to clear the entry blocked on interface eth1/0/4.
Switch# clear ip ip-mac-port-binding violation interface eth1/0/4
Switch#
37-2 ip ip-mac-port-binding
This command is used to enable the IMPB access control for port interfaces. Use the no form of this
command to disable the IMPB access control function.
ip ip-mac-port-binding [MODE]
no ip ip-mac-port-binding
Parameters
MODE
(Optional) Specifies the IMPB access control mode.
strict-mode: Specifies to perform strict mode access control.
loose-mode: Specifies to perform loose mode access control.
If the mode option is not specified, the strict-mode is used.
Default
By default, this option is disabled.
Command Mode