D-Link DGS-1510 Series - Simple Network Management Protocol (SNMP) Commands

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
550
63. Simple Network Management Protocol
(SNMP) Commands
63-1 show snmp trap link-status
This command is used to display the per interface link status trap state.
show snmp trap link-status [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
(Optional) Specifies the interface ID. If no interface is specified, then
all interfaces will be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display per interface link up/down trap state.
Example
This example shows how to display the interface’s link up/down trap state for port eth1/0/1 to eth1/0/9.
Switch# show snmp trap link-status interface eth1/0/1-1/0/9
Interface Trap state
------- -------------
eth1/0/1 Enabled
eth1/0/2 Enabled
eth1/0/3 Disabled
eth1/0/4 Enabled
eth1/0/5 Enabled
eth1/0/6 Disabled
eth1/0/7 Enabled
eth1/0/8 Enabled
eth1/0/9 Enabled
Switch#
63-2 show snmp-server
This command is used to display the SNMP server’s global state settings and trap related settings.
show snmp-server [traps]
Parameters