EasyManuals Logo

D-Link DGS-1510 Series User Manual

D-Link DGS-1510 Series
711 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
118
10. Basic IPv6 Commands
10-1 clear ipv6 neighbors
This command is used to clear IPv6 neighbor cache dynamic entries.
clear ipv6 neighbors {all | INTERFACE-ID}
Parameters
all
Specifies to clear the dynamic neighbor cache entries associated
with all interfaces.
INTERFACE-ID
Specifies to clear dynamic neighbor cache entries associated with
the specified interface will be cleared.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command will only clear dynamic neighbor cache entries.
Example
This example shows how to clear IPv6 neighbor cache entries associated with interface VLAN 1:
Switch# enable
Switch# clear ipv6 neighbors vlan1
Switch#
10-2 ipv6 address
This command is used to manually configure an IPv6 addresses on the interface. Use the no form of
this command to delete a manually configured IPv6 address.
ipv6 address {IPV6-ADDRESS/PREFIX-LENGTH | IPV6-ADDRESS link-local}
no ipv6 address {IPV6-ADDRESS/PREFIX-LENGTH | IPV6-ADDRESS link-local}
Parameters
IPV6-ADDRESS
Specifies the IPv6 address and the length of prefix for the subnet.
PREFIX-LENGTH
Specifies the length of the prefix. The prefix of the IPv6 address is
also a local subnet on the interface.
link-local
Specifies a link-local address to be configured.
Default
None.
Command Mode

Table of Contents

Other manuals for D-Link DGS-1510 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DGS-1510 Series and is the answer not in the manual?

D-Link DGS-1510 Series Specifications

General IconGeneral
LayerLayer 2+
IGMP SnoopingYes
Static RoutingYes
Humidity10% to 90% non-condensing
SeriesDGS-1510
TypeSmart Managed Switch
VLAN SupportYes
QoSYes
ManagementWeb-based, CLI, SNMP
Power SupplyInternal
MAC Address Table16K entries
802.3ad Link AggregationYes
Spanning Tree Protocol (STP)Yes, STP/RSTP/MSTP
Jumbo Frame SupportYes, up to 9KB
Power ConsumptionVaries by model
DimensionsVaries by model
WeightVaries by model
Operating Temperature0°C to 40°C
Storage Temperature-40°C to 70°C
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p

Related product manuals