D-Link DGS-1510 Series - Web Authentication Commands

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
663
77. Web Authentication Commands
77-1 web-auth enable
This command is used to enable the Web authentication function on the port. Use the no form of this
command to disable the Web authentication function.
web-auth enable
no web-auth enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command allows hosts connected to the port to do authentication via the Web browser.
Example
This example shows how to enable the Web authentication function on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# web-auth enable
Switch(config-if)#
77-2 web-auth page-element
This command is used to customize the Web authentication page elements. Use the no form of this
command to revert to the default setting.
web-auth page-element {page-title STRING | login-window-title STRING | username-title
STRING | password-title STRING | logout-window-title STRING | copyright-line LINE-
NUMBER title STRING}
no web-auth page-element {page-title | login-window-title | username-title | password-title |
logout-window-title | copyright-line}
Parameters
page-title STRING
Specifies the title of the Web authentication page. The maximum
number can be up to 128 characters.
login-window-title STRING
Specifies the title of the Web authentication login window. The
maximum number can be up to 64 characters.
username-title STRING
Specifies the user name title of Web authentication login window.
The maximum number can be up to 32 characters.