D-Link DGS-1510 Series User Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
74
When the service password encryption option is disabled and the password is specified in the plain
text form, the password will be in plain text form. However, if the password is specified in the
encrypted form or if the password has been converted to the encrypted form by the last enable
password encryption option, the password will still be in the encrypted form. It cannot be reverted
back to plain text.
The password affected by this command includes the user account password, enable password, and
the authentication password.
Example
This example shows how to enable the encryption of the password before stored in the configuration
file.
Switch# configure terminal
Switch(config)# service password encryption
Switch(config)#
5-13 show terminal
This command is used to obtain information about the terminal configuration parameter settings for
the current terminal line. Use this command in any EXEC mode or any configuration mode.
show terminal
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information about the terminal configuration parameters for the current
terminal line.
Example
This example shows how to display information about the terminal configuration parameter settings
for the current terminal line.
Switch# show terminal
Terminal Settings:
Length: 24 lines
Width: 80 columns
Default Length: 24 lines
Default Width: 80 columns
Baud rate: 9600 bps
Switch#

D-Link DGS-1510 Series Specifications

General

Layer	Layer 2+
IGMP Snooping	Yes
Static Routing	Yes
Humidity	10% to 90% non-condensing
Series	DGS-1510
Type	Smart Managed Switch
VLAN Support	Yes
QoS	Yes
Management	Web-based, CLI, SNMP
Power Supply	Internal
MAC Address Table	16K entries
802.3ad Link Aggregation	Yes
Spanning Tree Protocol (STP)	Yes, STP/RSTP/MSTP
Jumbo Frame Support	Yes, up to 9KB
Power Consumption	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p