D-Link DGS-1510 Series - Page 76

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
73
Parameters
console
Specifies the local console terminal line.
telnet
Specifies the Telnet terminal line
ssh
Specifies the SSH terminal line
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The line command is used to enter the Line Configuration Mode.
Example
This example shows how to enter the Line Configuration Mode for the SSH terminal line and
configures its access class as ”vty-filter”.
Switch# configure terminal
Switch(config)# line ssh
Switch(config-line)# access-class vty-filter
Switch(config-line)#
5-12 service password-encryption
This command is used to enable the encryption of the password before stored in the configuration file.
Use the no form of this command to disable the encryption.
service password-encryption [7 | 15]
no service password-encryption
Parameters
7
Specifies the password in the encrypted form based on SHA-1.
15
Specifies the password in the encrypted form based on MD5.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level:15.
Usage Guideline
The user account configuration information is stored in the running configuration file and can be
applied to the system later. If the service password-encryption command is enabled, the password
will be stored in the encrypted form.