D-Link DGS-1510 Series User Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
597
67. Storm Control Commands
67-1 snmp-server enable traps storm-control
This command is used enable or control the command to enable sending SNMP notifications for
storm control. Use the no form of this command to disable sending SNMP notifications.
snmp-server enable traps storm-control [storm-occur] [ storm-clear]
no snmp-server enable traps storm-control [storm-occur] [ storm-clear]
Parameters
storm-occur
(Optional) Specifies to send a notification when a storm event is
detected.
storm-clear
(Optional) Specifies to send a notification when a storm event is
cleared.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command with keyword storm-occur and storm-clear enables or disables the notifications for
storm control module. If no optional keywords is specified, both storm-occur and storm-clear
notifications are enabled or disabled. If you enter the command with a keyword, only the specified
notification type is enabled or disabled.
Example
This example shows how to enable sending trap for storm control for both storm occurred and cleared.
Switch#configure terminal
Switch(config)#snmp-server enable traps storm-control
Switch(config)#
67-2 storm-control
This command is used to configure the device to protect the device from broadcast, multicast, and DA
unknown packet storm attacks. Use the no form of this command to restore the function to its default
settings.
storm-control {{broadcast | multicast | unicast} level {pps PPS-RISE [PPS-LOW] | kbps
KBPS-RISE [KBPS-LOW] | LEVEL-RISE [LEVEL-LOW]} | action {shutdown | drop | none}}
no storm-control {broadcast | multicast | unicast | action}
Parameters
broadcast
Specifies to set the broadcast rate limit.
multicast
Specifies to set the multicast rate limit.

D-Link DGS-1510 Series Specifications

General

Layer	Layer 2+
IGMP Snooping	Yes
Static Routing	Yes
Humidity	10% to 90% non-condensing
Series	DGS-1510
Type	Smart Managed Switch
VLAN Support	Yes
QoS	Yes
Management	Web-based, CLI, SNMP
Power Supply	Internal
MAC Address Table	16K entries
802.3ad Link Aggregation	Yes
Spanning Tree Protocol (STP)	Yes, STP/RSTP/MSTP
Jumbo Frame Support	Yes, up to 9KB
Power Consumption	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p