D-Link DGS-1510 Series - Page 105

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
102
ip http accounting exec {default | METHOD-LIST}
no ip http accounting exec
Parameters
default
Specifies to do accounting based on the default method list.
METHOD-LIST
Specifies the name of the method list to use.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
For accounting via the method list to take effect, enable AAA first by using the aaa new-model
command. Create the method list first by using the aaa accounting exec command. If the method list
does not exist, the command does not take effect.
Example
This example shows how to specify that the method configured for AAA should be used for
accounting for HTTP server users. The AAA accounting method is configured as the RADIUS
accounting method.
Switch# configure terminal
Switch(config)# aaa accounting exec list-1 start-stop group radius
Switch(config)# ip http accounting exec list-1
Switch(config)#
8-19 login authentication
This command is used to configure the method list used for login authentication via a specific line Use
the no form of this command to revert to the default method list.
login authentication {default | METHOD-LIST}
no login authentication
Parameters
default
Specifies to authenticate based on the default method list.
METHOD-LIST
Specifies the name of the method list to use.
Default
By default, the default method list is used.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 15.